I-7570
Introduction: The I-7570 is a Serial to HART converter that can function as either a HART master or HART slave. It allows users to access HART slave devices via RS-232, RS-422, or RS-485 interfaces. These devices may include transmitters, actuators, or current output devices. The module supports configuration via the HC_Tool utility and simulation via the HDS utility, making it ideal for both integration and development environments.
Serial to HART Converter – ICP DAS
Key Features
- Dual Role: Operates as HART master or HART slave
- HART Protocol Support: Supports short/long frame, burst mode, point-to-point and multi-drop modes
- Device Capacity: Connects up to 15 HART slave devices
- Dual HART Masters: Allows two HART masters per channel
- Utility Software: Includes HC_Tool for configuration and HDS for simulation
- FDT Compatibility: Supports PACTware, FieldCare, and Siemens PDM
- OPC Server: Compatible with HART OPC Server from HART Communication Foundation
- ESD Protection: 4 KV contact per terminal
Specifications
- COM Ports: RS-232 / RS-422 / RS-485 via 9-pin screw terminal block
- Baud Rate: 1200 bps (FW v1.1), up to 115200 bps (FW v1.1 / HW v1.2)
- Data Format: Odd parity, 8 data bits, 1 stop bit (FW v1.1); N/O/E parity, 8 data bits, 1/2 stop bits (FW v1.1 / HW v1.2)
- HART Port: 1 channel, 2-pin screw terminal block
- Terminator Resistor: Selectable 250 O
- Isolation: 3000 VDC
- Power Input: +10 ~ +30 VDC (unregulated)
- Power Protection: Reverse polarity and over-voltage brown-out protection
- Power Consumption: 1 W
- LED Indicators: PWR, TxD, RxD
- Installation: DIN-Rail or wall mounting
- Dimensions: 121 x 72 x 35 mm (H x W x D)
- Operating Temperature: -25°C to +75°C
- Storage Temperature: -30°C to +85°C
- Humidity: 5% to 95% RH, non-condensing